Batería SAI de repuesto ONLINE USV-Systeme BCZ2000 — 1 ud., gris, 10,68 kg, compatible con ZINTO 2000 (2017)

Replacement UPS battery ONLINE USV-Systeme BCZ2000 is a single grey battery designed to restore or extend backup power for ONLINE USV-Systeme ZINTO 2000 (2017). With a compact footprint of approximately 200 mm width and 150 mm height and a shipping weight of 10.68 kg, this battery follows original-spec form factor and physical characteristics to ensure proper fit and safe installation in the compatible UPS unit. It is supplied as one unit and intended specifically for use where the original battery needs replacement to recover rated runtime and reliability for protected equipment.

Advantages

This replacement battery matches the physical dimensions and weight profile of the original pack to enable straightforward installation and consistent electrical compatibility with the ZINTO 2000 (2017) UPS. It is supplied as a single, ready-to-install unit in grey finish and is suitable for systems that require an OEM-equivalent battery to maintain designed backup durations. The design simplifies service and reduces downtime by allowing direct swap-in replacement without the need for major UPS modifications.

Suitable for

• Restoring backup power in ONLINE USV-Systeme ZINTO 2000 (2017) units
• Server rooms and rack installations requiring original-spec replacement batteries
• Network and telecom equipment that depend on uninterrupted power during outages
• Preventive maintenance programs where end-of-life battery packs are replaced on schedule

Key specifications

• Quantity included: 1 battery
• Approximate dimensions: 200 mm (W) × 150 mm (H)
• Weight: 10.68 kg
• Color: Grey
• Compatibility: designed for use with ZINTO 2000 (2017) UPS models

How to use

Before replacing the battery, power down and disconnect the UPS from mains and attached loads following the UPS manufacturer’s safety instructions. Remove the front or access panel of the UPS as required, carefully disconnect the depleted battery pack connectors, and remove the old battery. Install the BCZ2000 replacement in the same orientation, connect wiring firmly to the terminals, secure the battery in place, and reassemble the UPS enclosure. After installation, reconnect the UPS to mains and perform any recommended battery calibration or self-test procedures provided by the UPS to confirm correct operation.

Recommendations

Use this replacement battery only in the specified ZINTO 2000 (2017) model or other systems explicitly listed as compatible by the UPS manufacturer. Store and install the battery in a dry, temperature-controlled environment and follow local regulations for handling and disposal of lead-acid or sealed battery units. If unsure about installation, consult qualified service personnel to avoid damage or safety risks.