Cable de red LogiLink 0,25 m RJ-45 Cat6a verde

Patch Cable Cat.6A 10G S/FTP PIMF PrimeLine green 0.25 m by LogiLink is a short networking cable with RJ-45 connectors on both ends, designed for high-speed 10 Gigabit Ethernet connections. The cable uses S/FTP (shielded foiled twisted pair with overall braid) construction, AWG 26/7 conductors of bare copper and an LSZH (low smoke zero halogen) jacket. It complies with ISO/IEC 11801, EN50288 and TIA/EIA 568-C.2 standards.

Advantages

The LogiLink Cat6A cable provides reliable signal integrity through S/FTP shielding and PIMF (pair in metal foil) pair shielding, reducing crosstalk and external electromagnetic interference. Its AWG 26/7 bare copper conductors offer stable conductivity for 10G data rates over short runs, while the LSZH jacket limits smoke and toxic gas emission in case of fire. The compact 0.25 m length and green colour make it easy to identify and manage in dense patch-panels and short patching scenarios.

Suitable for

• Short connections between network equipment in racks and patch panels
• High-speed 10 Gigabit Ethernet links over short distances
• Shielded environments where EMI reduction is required
• Cable management where colour-coding is used

Key specifications

• Length: 0.25 m
• Connectors: RJ-45 to RJ-45
• Cable category: Cat.6A (10G)
• Shielding: S/FTP (PIMF + overall braid)
• Conductor: AWG 26/7, bare copper
• Jacket: LSZH (low smoke zero halogen)
• Standards: ISO/IEC 11801, EN50288, TIA/EIA 568-C.2
• Colour: Green
• Weight: 20 g

How to use

Connect one RJ-45 connector to a network port on a switch, router or network interface and the other RJ-45 connector to the corresponding port on the target device or patch panel. Ensure connectors are fully inserted until the latch clicks. Use the 0.25 m cable for short patching runs to avoid excess slack and maintain tidy cable routing within racks or enclosures.

Recommendations

For optimal performance, use this Cat6A patch cable for short, shielded connections in rack-mounted environments and avoid tight bends or kinks. Maintain proper grounding of shielded equipment and patch panels to ensure the shielding effectiveness.