Compresor de aire AWTools AC50V 50L 3,0HP Black Line

AWTools AC50V 50L 3.0HP Black Line is a stationary air compressor designed to provide a reliable source of compressed air for workshops, garages and small businesses. With a vertical 50‑litre tank and a 3.0 HP motor, the unit supplies air for pneumatic tools, tyre inflation and general workshop use while occupying a compact floor footprint. Standard fittings and an accessible control panel allow straightforward connection and routine operation.

Advantages

The vertical tank layout reduces the footprint compared with horizontal models, making it suitable for constrained shop spaces. A 50 L capacity balances short air reserve with quick recovery times from the 3.0 HP motor, which is intended for light-to-medium continuous duty. The compressor includes standard workshop connections and an easily readable control area to simplify tool hookup and pressure monitoring. The design and components focus on practical, everyday workshop needs.

Suitable for

Key specifications

How to use

Position the compressor on a level, stable surface with adequate ventilation and secure electrical supply according to local regulations. Connect pneumatic tools using the standard fittings on the outlet manifold, set the required working pressure via the regulator and verify the gauge reading before operation. Monitor the tank pressure and allow the motor to reach cut‑out and cut‑in cycles; avoid exceeding recommended duty cycles and observe warm-up times after extended idle periods. Drain the tank regularly through the drain valve to remove accumulated condensate and reduce internal corrosion.

Recommendations

Use appropriate personal protective equipment when operating pneumatic tools. Maintain the compressor with periodic inspections: check belts (if applicable), fittings, hoses and pressure relief devices. Follow the manufacturer's service intervals for oil changes and filter replacements when applicable to preserve performance and extend service life.