CyberPower RBP0157 Batería SAI Plomo-ácido (VRLA) 48 V 9 Ah

Battery pack CYBERPOWER RBP0157 12V 7Ah for UPS backup power is a sealed lead-acid replacement battery designed to restore or extend runtime in compatible uninterruptible power supply (UPS) units. With a nominal voltage of 12 volts and a capacity of 7 ampere-hours, this battery pack enables orderly shutdowns and temporary power for critical devices during mains interruptions. It is intended for direct swap-in replacement in supported CYBERPOWER models and similar UPS systems that accept a 12V 7Ah sealed lead-acid module.

Advantages

This replacement battery offers a compact form factor and maintenance-free sealed construction, reducing the need for user service. The 12V 7Ah capacity balances runtime and size for small office and home UPS applications, providing predictable backup duration for networking equipment, workstations and peripheral devices. The battery is pre-wired for straightforward installation and manufactured to meet common safety and performance expectations for UPS battery modules.

Suitable for

• Small office or home UPS units requiring a 12V 7Ah sealed lead-acid battery
• Backup power for routers, modems and network switches
• Maintaining desktop PCs and point-of-sale terminals during brief outages
• Protecting external hard drives and NAS devices during power interruptions

Key specifications

• Nominal voltage: 12 V
• Capacity: 7 Ah
• Battery type: sealed lead-acid (maintenance-free)
• Typical application: UPS backup module for small-form UPS units
• Physical characteristic: compact rectangular pack suitable for user-replaceable UPS compartments

How to use

Before replacing the battery, power down connected equipment if possible and unplug the UPS from the mains. Open the UPS battery compartment according to the manufacturer's instructions, disconnect the depleted battery by removing the connector or terminal leads, and remove the old pack. Install the CYBERPOWER 12V 7Ah replacement by seating it in the compartment and reconnecting the wiring in the same orientation. Close the compartment, reconnect the UPS to mains power and allow the unit to charge the new battery following the UPS charging recommendations. After replacement, verify UPS status indicators and perform a controlled test to confirm battery operation.

Recommendations

Store unused batteries in a cool, dry place and avoid freezing temperatures. Replace batteries in matched pairs or with the same type specified by the UPS manufacturer when the unit indicates end-of-life. Dispose of depleted sealed lead-acid batteries according to local regulations at designated recycling points.