Disco de lijado (180 mm) para afiladora húmeda Einhell TC-WG 200 — disco de afilado de repuesto

Replacement 180 mm grinding wheel designed for use with Einhell wet grinder TC-WG 200. This honing wheel is intended for wet sharpening and material removal, delivering a uniform abrasive surface that supports controlled grinding and helps reduce heat buildup during use. The wheel is shaped and sized to mount on the TC-WG 200 spindle and is suitable for restoring edges, shaping metal parts and tools, and general workshop grinding tasks.

Advantages

The wheel provides a consistent abrasive surface optimized for wet operation, which helps limit thermal damage to workpieces and prolong abrasive life. Its 180 mm diameter offers a balance between contact area and precision, allowing efficient stock removal while maintaining control. Designed specifically to fit the TC-WG 200 mounting requirements, it is straightforward to install and replace, reducing downtime during maintenance or tool servicing.

Suitable for

• Wet sharpening of knives, chisels and cutting tools
• Shaping and profiling metal components
• Removing burrs and restoring worn edges
• General workshop grinding tasks where wet cooling is preferred

Key specifications

• Diameter: 180 mm
• Type: Honing / grinding wheel for wet operation
• Intended mounting: Compatible with Einhell TC-WG 200 spindle dimensions
• Primary use: Edge restoration, shaping, material removal
• Operating mode: Wet grinding to reduce heat and extend wheel life

How to use

Ensure the wet grinder TC-WG 200 is switched off and disconnected from power before fitting the replacement wheel. Remove the protective guard and existing wheel according to the machine manual, then mount the 180 mm honing wheel on the spindle, securing it with the appropriate flange and fastening hardware. Reinstall the guard and reconnect the machine. For wet grinding, set the coolant reservoir and water feed to provide a steady flow to the wheel face. Operate the grinder at the machine’s recommended speed, applying light, consistent pressure and moving the workpiece evenly across the wheel to avoid grooves or uneven wear.

Recommendations

Use suitable personal protective equipment, including eye protection and gloves. Monitor water flow during wet operation to ensure effective cooling and swarf removal. Replace the wheel if signs of cracking, excessive wear, or imbalance appear. Follow the TC-WG 200 user manual for specific mounting torque and safety instructions.