Disco de sierra circular Bosch 2 608 644 126 14 cm para placas laminadas

The Bosch 2 608 644 126 circular saw blade (14 cm diameter) is designed for cutting laminated panels with accuracy and minimal tearing. Made for use in portable circular saws and table saws that accept a 20 mm bore, this blade provides a balance of cutting speed and edge quality suitable for furniture components, worktops, shelving and other laminated board applications. The blade's tooth geometry and hardness are matched to produce clean cross-cuts and rip cuts in laminated surfaces while reducing chipping on the decorative face.

Advantages

This 14 cm circular saw blade offers precise, chip-reduced cutting on laminated panels due to optimized tooth geometry and a hardness suited to composite materials. Its construction delivers consistent performance over a series of cuts, helping maintain edge quality and reducing the need for secondary finishing. The standard 20 mm bore size enables compatibility with many common saws, allowing straightforward installation and stable operation.

Suitable for

Key specifications

How to use

Install the blade on a compatible circular saw or table saw with a 20 mm arbor, ensuring the saw is disconnected from power while fitting. Check blade direction markings and secure the blade flange and nut to the manufacturer's torque specification. Set appropriate cutting speed and feed rate for laminated panels, and use a stable work support or fence to guide the material. Make test cuts on scrap material to verify alignment and edge quality before proceeding with final cuts. Wear approved eye and hearing protection and follow all tool safety procedures.

Recommendations

For best results when cutting laminated panels, use a zero-clearance insert or sacrificial backing board to support the laminate face and minimize tear-out. Maintain steady, moderate feed rates and avoid excessive force to prolong blade life and preserve edge finish. Periodically inspect the blade for wear and replace it when cutting quality declines.