Hypertec 253191-HY accesorio para cable pasacables

The Hypertec 253191-HY cable boot is made for RJ45 connectors to protect the connector and provide strain relief for network cables. This grey boot comes in a pack of 10 and is intended to reduce wear on the mating point between cable and connector, helping to preserve reliable network connections during installation and regular use.

Advantages

The Hypertec ProConnectLite RJ45 sleeve offers a compact design that fits standard RJ45 plugs, provides mechanical protection to the connector head and cable exit, and reduces the risk of accidental cable bending or pull damage. Supplied in a pack of 10, the boots are suitable for small deployments and maintenance tasks where multiple connectors require protection.

Suitable for

Key specifications

How to use

Slide the boot over the cable before fitting the RJ45 connector, then crimp the connector as usual and push the boot forward until it fully covers the connector head and latch area. Ensure the boot sits snugly against the connector to provide effective strain relief and protection. For pre-terminated cables, remove the connector if necessary to install the boot, or use boots designed for fitted assemblies.

Recommendations

Choose the correct boot size for your cable diameter and verify compatibility with the specific RJ45 connector used. Store unused boots in a dry environment away from direct sunlight to maintain material properties. Replace boots that show visible wear, cracking, or deformation.