Laserliner MultiWet-Finder Plus higrómetro electrónico negro blanco pantalla digital

The Laserliner MultiWet-Finder Plus is an electronic material moisture measuring device for non-destructive location and evaluation of moisture distribution and moisture damage in walls, floors and ceilings. It combines surface moisture scanning with a climate sensor and digital interface to record ambient temperature, relative humidity and calculated dew point. The instrument displays numerical moisture index values, supports material-specific settings for cement screed, anhydrite screed and concrete, and allows transfer of measured data to a PC for documentation and reporting.

Advantages

The device provides a quick overview of moisture severity and distribution during a survey and enables comparison of measured index values with reference points that are not affected by moisture. A 12-position LED display and configurable acoustic alarm help to signal limit-value exceedances; the LED indicator can be switched off if required. Material characteristics can be shown as CM % or mass %, and the digital connection interface allows export of recorded data for further analysis.

Suitable for (tasks / use cases)

Key specifications

How to use

Switch on the MultiWet-Finder Plus and select the appropriate material characteristic if you need CM % or mass % readout. Perform a scan across the surface of the wall, floor or ceiling to locate areas with elevated moisture index values, using a non-affected reference point to establish a baseline. Observe the numerical display and the 12-position LED indicator; configure the acoustic alarm and limit values as required. Record ambient temperature, relative humidity and dew point via the climate sensor to support analysis of moisture behaviour. Connect the device to a PC through the digital interface to export and document measured data for reporting.

Recommendations

For reliable assessment, measure a reference point known to be dry before scanning damaged areas, set material type correctly, and document readings together with ambient climate parameters. Replace AAA batteries before extended use and transfer data to a PC for traceable reporting.