Llave de boca Gedore 6057350 peso 77g profundidad de embalaje 77mm altura 41mm

Open end wrench manufactured by Gedore to DIN 3118 with a 15° ring offset from the shaft and a 30° hexagon gap offset; UD-section at 15° offset. Available in sizes 8x10 mm to 12x14 mm with hexagon ends. Made from vanadium steel (31CrV3) with chrome plating. Not all features are standardized.

Advantages

The Gedore open end wrench offers corrosion resistance thanks to chrome plating and high strength and wear resistance from vanadium steel 31CrV3. Its offset ring and hexagon gap angles improve access to fasteners in confined or recessed areas. Multiple size options in the 8x10 to 12x14 mm range allow use on common metric fittings.

Suitable for

Key specifications

How to use

Select the wrench size that matches the fastener. Position the appropriate hexagon end on the nut or bolt head, ensuring full contact between flats to avoid rounding. Use the offset ring or hexagon gap to access fasteners in confined or recessed locations; apply steady torque without sudden excessive force. After use, clean any debris and store the tool in a dry place to maintain the chrome finish and prevent corrosion.

Recommendations

For safe and long-lasting performance, avoid using the wrench as a hammer or lever beyond its intended capacity, and inspect the tool regularly for wear or damage. Use the offset angles to improve access rather than increasing force; if a fastener is seized, apply proper penetrating lubricant and controlled torque increments.