Manguera de aspiración e impulsión Cellfast 38 mm x 25 m – para bombas, Negro

Suction and Pressure Hose Cellfast 38 mm x 25 m is a flexible hose designed for both suction and discharge applications with portable and stationary pumps. With a 38 mm inner diameter and 25 m length, this black hose is intended for garden irrigation, temporary water transfer and general-purpose pump connections. Its construction supports water flow in irrigation systems and short-term supply lines where a durable, flexible connection is required.

Advantages

The hose combines suction and pressure capability in a single assembly, reducing the need to change hoses between drawing and discharging water. Its 38 mm nominal bore provides adequate flow for many small to medium pump models while maintaining flexibility for easy handling and routing. The 25 m length allows longer reach without frequent coupling, and the black outer layer resists dirt and UV exposure during typical garden and outdoor use.

Suitable for

Key specifications

How to use

Attach one end of the hose securely to the pump inlet or outlet using appropriate hose clamps or connectors rated for the pump connections. Ensure the hose is free of sharp bends and kinks that could restrict flow. When using the hose for suction, prime the pump if required and position the hose end below the water surface to avoid air intake. For pressure (discharge) use, route the hose to the destination and secure fittings to prevent accidental detachment under pressure. After use, drain the hose, coil it loosely and store it away from prolonged UV exposure and extreme temperatures to prolong service life.

Recommendations

Check compatibility of fittings and clamps with your pump connections before installation. Avoid prolonged suction on muddy or debris-laden sources without appropriate pre-filtration to prevent abrasion and blockages. Replace the hose if you observe cuts, deep abrasions or permanent deformation that could affect suction or pressure performance.