Módulo de memoria CoreParts MMH9694/8GB 2 x 4 GB DDR2 240 pines DIMM ECC

The CoreParts DDR2 8GB 667MHz ECC memory module (MMH9694/8GB) contains 2 × 4 GB DDR2 chips with a clock speed of 667 MHz and ECC support. This green module is designed for use in PCs and servers where stable operation and error correction are required, allowing you to expand internal memory capacity while maintaining reliability.

Advantages

The module uses original chip sets from certified suppliers and offers ECC functionality for automatic detection and correction of single-bit memory errors. With an 8 GB capacity and DDR2 667 MHz specification, it provides compatibility with systems that accept DDR2 ECC modules and contributes to system stability under continuous or mission-critical loads.

Suitable for

• Legacy desktops requiring DDR2 memory upgrades
• Entry-level servers or workstations that support ECC DDR2
• Systems needing increased RAM capacity for stability and multitasking

Key specifications

• Internal memory: 8 GB (2 × 4 GB)
• Memory type: DDR2
• Clock speed: 667 MHz
• ECC: Yes (error-correcting code)
• Product colour: Green
• Weight: 0.01 kg
• Manufacturer part number (MPN): MMH9694/8GB
• EAN: 5711045328183

How to use

Power off the computer and disconnect it from mains power before installing the memory module. Open the case following the manufacturer’s instructions, locate the appropriate DDR2 ECC memory slot and align the notch on the module with the slot key. Firmly press the module into place until the retention clips engage. Reassemble the case, reconnect power and start the system. Verify that the system recognizes the full 8 GB and ECC functionality in the BIOS or operating system memory diagnostic tools.

Recommendations

Install matching DDR2 ECC modules in identical pairs where the motherboard requires paired channels; consult the motherboard manual for supported memory configurations and maximum capacities. Ensure BIOS/firmware supports DDR2 ECC before deployment in servers or critical systems.