Módulo transceptor SFP ADDER SFP-MM-LC-10G

The ADDER SFP-MM-LC-10G is a high-performance SFP transceiver module engineered for 10 Gigabit Ethernet links. Designed with a multi-mode LC connector, it supports transmission distances up to 300 meters over OM3 fiber and conforms to MSA (Multi-Source Agreement) standards for broad interoperability with networking equipment. Its compact SFP form factor allows installation in switches, routers and servers where standard SFP ports are used.

Advantages

This SFP transceiver provides reliable 10Gbps connectivity in multi-mode fiber environments with a compact footprint that preserves rack and port density. Compliance with MSA ensures predictable electrical and optical interfaces for compatibility across multiple vendors. The module’s support for OM3 fiber at distances up to 300 meters makes it suitable for typical data center and campus backbone links without requiring single-mode cabling.

Suitable for

• 10 Gigabit Ethernet uplinks between network switches in data centers
• Server to switch connections where SFP ports are available
• Campus or building backbone links using OM3 multi-mode fiber up to 300 meters
• Equipment replacement or expansion where MSA-compliant SFP modules are required

Key specifications

• Form factor: Small Form-factor Pluggable (SFP)
• Data rate: 10 Gigabit Ethernet
• Fiber type: Multi-mode (OM3)
• Connector type: LC duplex
• Maximum reach: Up to 300 meters over OM3 fiber
• Standards: MSA-compliant optical transceiver

How to use

Install the module into an SFP-compatible port on your switch, router or server while the host device is powered according to the equipment manufacturer’s instructions. Connect LC duplex multi-mode fiber cable (OM3) ensuring correct Tx/Rx polarity. Verify link status using the host device’s management interface and monitor for proper operation. If required, configure link speed and duplex settings in the network device; many modern devices negotiate 10Gbps automatically.

Recommendations

Handle the transceiver by its housing and keep protective dust caps on the LC connector when not in use. Use certified OM3 multi-mode fiber and maintain appropriate bend radii to preserve performance. Confirm compatibility with the target network equipment and follow the vendor’s installation guidelines to ensure stable 10 Gigabit operation.