NetApp 450GB 15K SAS 3,5 inch DS4243 X411A-R5-RFB

The NetApp 450GB 15K SAS 3.5" DS4243 X411A-R5-RFB is a high-performance enterprise hard drive designed for use in NetApp DS4243 enclosures and compatible SAS storage systems. With 450GB capacity, a 15,000 RPM spindle speed and a SAS interface, this 3.5" form factor drive is intended to deliver consistent, low-latency access for demanding data center workloads and storage arrays.

Advantages

This NetApp X411A-R5-RFB drive provides fast rotational speed (15K RPM) and a Serial Attached SCSI (SAS) interface for reliable data throughput and lower access latency compared with lower-RPM drives. The 3.5" form factor is compatible with standard enterprise trays and the DS4243 chassis, enabling straightforward replacement or capacity expansion. The drive model and manufacturer part number ensure compatibility verification for NetApp systems and service processes.

Suitable for

• Enterprise storage arrays and SAN deployments
• NetApp DS4243 disk shelf installations
• High-performance databases and transactional systems
• Virtualization hosts requiring low-latency disk access
• RAID configurations where 15K RPM performance is required

Key specifications

• Brand: NETAPP
• Model / MPN: X411A-R5-RFB
• EAN: 5711783975069
• Capacity: 450GB
• Spindle speed: 15,000 RPM
• Interface: SAS (Serial Attached SCSI)
• Form factor: 3.5"
• Category: HDD

How to use

Install the drive into a compatible NetApp DS4243 enclosure or another supported SAS backplane following the vendor's hardware installation procedures. Ensure the host system is powered down or that hot-swap procedures are followed if supported. After physical installation, verify the drive is recognized by the storage controller or operating system and configure it within your RAID or storage pool according to your existing storage architecture and NetApp guidelines.

Recommendations

Use the NetApp 450GB 15K SAS drive in environments requiring sustained transactional performance and predictable latency. Verify firmware and compatibility with your specific NetApp controller or DS4243 shelf documentation before deployment, and incorporate the drive into redundancy and backup plans to maintain data availability.