Material de impresión 3D Polymaker PB01039 PETG magenta 1 kg 1,75 mm

Polymaker PB01039 PETG Magenta is a 1 kg, 1.75 mm filament made from Polyethylene Terephthalate Glycol (PETG). This material offers a balance of printability and mechanical performance, providing better impact resistance and layer adhesion than PLA while being easier to print than ABS. The magenta color is suitable for both functional parts and visually striking prototypes.

Advantages

PolyLite PETG delivers a compromise between ease of printing and durability: it combines moderate heat resistance, strength, and straightforward printing behavior. The filament offers reliable layer adhesion, good impact resistance and consistent extrusion for stable prints. It is available in a 1 kg spool with 1.75 mm diameter suitable for most desktop FDM printers.

Suitable for

• Functional prototypes and mechanical parts requiring impact resistance
• Visual models and colorful prototypes in magenta
• Everyday 3D prints where balanced strength and printability are needed

Key specifications

• Material: PETG (Polyethylene Terephthalate Glycol)
• Brand / MPN: POLYMAKER / PB01039
• Color: Magenta
• Diameter: 1.75 mm
• Net weight: 1 kg
• EAN: 6938936707172

How to use

Load the 1.75 mm filament into a compatible FDM 3D printer and set print parameters within the recommended ranges. Typical printing temperatures are 230–240 °C with a heated bed at 70–80 °C. Print at moderate speeds (30–50 mm/s). Adjust retraction for your extruder type: direct drive around 1 mm at 20 mm/s, Bowden/indirect drive around 3 mm at 40 mm/s. Dry the filament at 65 °C for about 6 hours only if the material has absorbed moisture.

Recommendations

If you want the best surface finish, enable part cooling; for maximum part strength skip or minimize cooling. A fan set to around 20% provides a balance between surface quality and mechanical durability.