RUKO KES-FormC-90°-10,4x88mm relé PCB 24V AC 2 CO 8A

When a control signal must switch two independent circuits at once, a single-pole relay is not enough. The RUKO KES-FormC-90°-10,4x88mm provides two changeover contacts in a compact PCB-mount package, handling up to 8 A per contact at 250 V AC. Its 24 V AC coil and flux-proof construction make it suitable for dense industrial boards where space is limited and reliability matters.

Who is it for

Automation engineers, HVAC control builders, and PCB designers who need a double-pole double-throw (DPDT) relay with a low-power AC coil and a right-angle pin layout for horizontal mounting.

Main features

• 2 CO (DPDT) contact configuration
• 24 V AC coil voltage, 1.2 VA consumption
• 8 A rated current, 250 V AC rated voltage
• Silver nickel (AgNi) contacts for long life
• Flux-proof (RT I) for wave soldering
• PCB mount with 90° angled pins, 8 pins
• Operating temperature -40 to +70 °C

Specifications

• Contact configuration: 2 CO (2 Form C / DPDT)
• Coil voltage: 24 V AC
• Rated current (contacts): 8 A
• Rated voltage (contacts): 250 V AC
• Contact material: AgNi (Silver Nickel)
• Coil power consumption: 1.2 VA
• Dielectric strength (coil-contacts): 2000 V AC
• Dielectric strength (open contacts): 1000 V AC
• Operating temperature range: -40 to +70 °C
• Mounting type: PCB Mount
• Protection degree: RT I (Flux Proof)
• Electrical life (at rated load): 100,000 cycles
• Mechanical life: 10,000,000 cycles
• Operate time: 7 ms
• Release time: 10 ms
• Number of pins: 8
• Insulation class: Class F

Tips

Because the coil is AC, ensure your control voltage is truly 24 V AC; a DC supply will not operate the relay. The flux-proof housing allows wave soldering, but avoid ultrasonic cleaning after mounting.