Hypertec 314014-HY cable SATA 0,5 m SATA 7-Pin

The Tecline 314014 SATA cable is a 0.5 m SATA III data cable with 7-pin SATA connectors at both ends. Designed for internal PC use, the cable supports high-speed data transfer between storage devices such as hard disk drives and solid-state drives. Its red outer insulation provides clear visual identification inside a system build while maintaining the standard SATA connector profile for compatibility with motherboards and drives.

Advantages

This SATA 7-pin cable supports the SATA III interface for data rates up to the specification limit, offering reliable signal integrity for typical desktop and workstation storage configurations. The 0.5 m length reduces cable clutter in compact cases and helps maintain tidy airflow paths. The red jacket makes cable routing and troubleshooting easier without affecting electrical performance. Both ends use the standardized 7-pin SATA connector for straightforward, tool-free installation.

Key specifications

How to use

Power off the computer and unplug it from the mains before installing the cable. Connect one 7-pin SATA connector to the SATA data port on the motherboard and the other to the data interface on the drive, ensuring the keyed connector orientation matches the ports. After completing connections, secure drives in their bays, restore power and verify that the drive is detected in the system BIOS or operating system. For best performance, use motherboard SATA ports that support SATA III speeds.

Recommendations

Avoid sharp bends, kinks, and excessive tension on the cable to preserve signal integrity. Keep SATA data cables separated from high-current power lines where possible, and choose an appropriate cable length to reduce excess cabling inside the case. For optimal throughput, pair this cable with drives and motherboard ports that both support SATA III.