Tira LED PHANTEKS PH-NELEDKT_M1_WT01 — universal 1000 mm, 5 V, 10,5 W, blanca

PHANTEKS PH-NELEDKT_M1_WT01 is a universal 1000 mm white LED strip designed for interior lighting of computer cases and chassis. The strip operates at 5 V with a maximum power draw of 10.5 W and a maximum current of 2.1 A, providing even, cool white illumination for component accenting and general ambient lighting inside PC builds. It is supplied as a single-piece unit intended for mounting inside towers, small form factor cases or display rigs where discreet, consistent lighting is required.

Advantages

The LED strip delivers consistent white light along its full 1000 mm length, enabling uniform accent and ambient illumination without bright spots. Low-voltage 5 V operation reduces the need for complex power arrangements and is compatible with common motherboard and controller outputs. Compact form factor and straightforward installation make it suitable for tight spaces inside modern chassis while the rated 10.5 W power ensures sufficient output for visible component highlighting without excessive heat generation.

Suitable for

• Interior accent lighting in desktop PC cases
• Illuminating GPUs, motherboards and drive bays for component visibility
• Ambient lighting in small form factor and full-tower builds
• Showcases, display rigs or test benches that require neutral white illumination

Key specifications

• Length: 1000 mm
• Operating voltage: 5 V
• Maximum power consumption: 10.5 W
• Maximum output current: 2.1 A
• Color tone: white (neutral/cool depending on implementation)
• Pack quantity: 1 strip

How to use

Mount the LED strip inside the computer case on a clean, dry surface using the included adhesive or recommended mounting brackets. Connect the strip to a compatible 5 V power source or controller that can supply at least 2.1 A and supports the strip’s connector type. Verify polarity and connector alignment before powering on. After connection, route cables to avoid obstruction of airflow or contact with hot components, then secure cables with ties or clips. Test the strip at low power or with system off to confirm correct operation before regular use.

Recommendations

For best results, place the strip where it can evenly illuminate target components and avoid direct contact with high-temperature surfaces such as heatsinks. Ensure your controller or motherboard header can supply the required current and use a dedicated cable route to maintain clean airflow and neat cable management. If using multiple strips, calculate combined current draw to avoid overloading the power source.