Cable de parcheo Delta CAT 5e 5 m, U/UTP, RJ-45 a RJ-45, 2x 90° en ángulo, blanco

Delta CAT 5e patch cable, 5 m length, U/UTP unshielded construction with RJ-45 male connectors on both ends. Both plugs are 90° angled to allow space-saving connections behind equipment or in tight cable routes. Gold-plated contact surfaces ensure consistent electrical contact. The cable is intended for Ethernet networks up to Cat5e performance and is suitable for connecting routers, switches, patch panels and standard home or office network devices.

Advantages

This Delta CAT 5e cable combines a 5 meter reach with two 90° RJ-45 plugs to simplify installations where straight plugs would obstruct furniture or rack space. The unshielded U/UTP design supports Cat5e network speeds while the gold-plated contacts provide reliable mating with RJ-45 sockets. The white outer jacket makes the cable easy to route and visually integrate into light-coloured interiors.

Suitable for

• Connecting routers to switches or modems in home and small office networks
• Patch panel to switch connections in wiring closets where angled plugs reduce stress on ports
• Wall-mounted or behind-furniture installations with limited clearance
• General Ethernet links requiring Cat5e performance over a 5 m distance

When it may not be suitable

The cable uses an unshielded U/UTP structure and copper-clad aluminium (CCA) conductors; it is not appropriate for environments with strong electromagnetic interference where a shielded cable would be required. For installations that demand copper solid conductors or standards specifying pure copper cabling, this CCA cable may not meet those requirements.

Key specifications

• Category: Cat5e (U/UTP)
• Length: 5 m
• Connectors: RJ-45 male to RJ-45 male, both 90° angled
• Conductor type: copper-clad aluminium (CCA)
• Contact plating: gold-plated contacts
• Colour: white outer jacket
• Pairing standard: EIA/TIA 568B pairing
• Performance: supports 10/100/1000 Mbit/s (Gigabit Ethernet) at Cat5e

How to use

Plug each 90° RJ-45 connector into the network device ports (router, switch, patch panel or network jack) ensuring the angled orientation matches available clearance. The cable is plug-and-play and requires no additional configuration. Route the cable along walls or cable channels, avoiding sharp bends near the connectors to reduce mechanical stress. Use the 5 m length to bridge typical room-to-equipment distances without intermediate couplers.

What to consider before purchase

• Verify that an unshielded Cat5e cable with CCA conductors meets your network and installation requirements
• Confirm that angled RJ-45 plugs fit the intended ports and do not obstruct adjacent connectors
• Ensure 5 m length is suitable for the distance between devices without excess slack or strain

Recommendations

Use the angled connectors where space is limited and keep bend radius gentle near the plugs. For installations in electrically noisy environments or where maximum long-term reliability and compliance with pure-copper cabling standards are required, consider selecting a shielded or solid-copper alternative.