2-power 15.6" 1920x1080 FHD LED On-Cell Touch (2P-N156HCN-E5A)

A cracked or dim laptop screen can halt productivity and strain your eyes. This 2-Power 15.6-inch replacement panel restores crisp Full HD visuals and responsive touch, making your notebook feel new again. It is a direct-fit LCD screen for compatible laptops, offering a cost-effective alternative to replacing the entire device.

Who is it for

This panel is ideal for DIY repair enthusiasts, IT technicians, and anyone looking to extend the life of a laptop with a broken or faulty display. If your current screen has dead pixels, cracks, or backlight issues, this replacement brings back a bright, clear image and full touch functionality.

Main features

• 15.6-inch IPS display with 1920x1080 Full HD resolution for sharp, vibrant visuals.
• On-cell touch technology provides smooth and accurate touch response without a separate digitizer.
• LED backlight with 250 cd/m² brightness ensures comfortable viewing in various lighting conditions.
• Glossy finish enhances color depth and contrast, ideal for multimedia and everyday use.
• Standard 30-pin eDP connector for straightforward installation in compatible laptops.
• Wide 80° viewing angles (left/right/up/down) maintain image quality from different positions.
• Low power consumption (3.5W typical) helps preserve battery life.

Specifications

• Screen size: 15.6 inches
• Resolution: 1920 x 1080 (Full HD)
• Panel type: IPS (In-Plane Switching)
• Touchscreen: Yes, On-Cell Touch
• Backlight: WLED
• Brightness: 250 cd/m²
• Color gamut: 45% NTSC
• Response time: 25 ms
• Viewing angles: 80/80/80/80 (L/R/U/D)
• Connector: 30-pin eDP
• Surface finish: Glossy
• Refresh rate: 60 Hz
• Aspect ratio: 16:9
• Power consumption: 3.5W (typical)
• Mounting brackets: Not included (bare panel)

Tips

Before ordering, verify that your laptop's original screen has the same size, resolution, connector type (30-pin eDP), and mounting hole positions. Touch functionality may require a compatible touch controller on the motherboard. Handle the panel by its edges to avoid fingerprints or pressure damage, and disconnect the battery before installation.