32GB ADATA DIMM 6000 (2x 16 GB) Dual-Kit (negro, AX5U6000C3616G-DTLABRBK, XPG Lancer Blade RGB, INTEL XMP, AMD EXPO)

XPG LANCER BLADE RGB DDR5 32GB 6000MHz is a 288-pin DIMM memory module that delivers 32 GB of DDR5 capacity with 6000 MHz clock speed, CAS latency 36 and on-die ECC for enhanced stability. The module comes in a black low-profile heatsink design with integrated RGB lighting and supports AMD EXPO and Intel XMP 3.0 for simplified overclocking. Built-in Power Management IC improves power supply stability while lower DDR5 operating voltages increase energy efficiency compared with DDR4.

Advantages

The compact low-profile heatsink fits into smaller PC cases and avoids interference with tower CPU coolers while providing a clean aesthetic. RGB lighting offers multiple effects and can be controlled via major motherboard RGB software or XPG Prime for synchronized light shows across compatible XPG devices. On-die ECC increases run-time stability and high-quality ICs and PCB construction support reliable performance and overclocking. PMIC-equipped power management and support for AMD EXPO and Intel XMP 3.0 simplify tuning and improve power efficiency.

Suitable for

• Gaming PCs requiring 32 GB DDR5 memory
• Compact builds with limited clearance for tall memory modules
• Systems where RGB lighting synchronization is desired
• Users who want easy overclocking via XMP 3.0 or AMD EXPO
• Workloads that benefit from enhanced stability provided by on-die ECC

Key specifications

• Capacity: 32 GB
• Type: DDR5
• Speed: 6000 MHz
• CAS Latency: 36
• Form factor: 288-pin DIMM
• Memory voltage: 1.4 V, 1.1 V
• On-die ECC: Yes
• RGB lighting: Yes (software control, XPG Prime compatible)
• Support: AMD EXPO, Intel XMP 3.0
• Color: Black

How to use

Install the module into an available 288-pin DDR5 DIMM slot on a compatible motherboard, observing the correct orientation and notch alignment. Enable XMP 3.0 or AMD EXPO in the motherboard BIOS/UEFI to apply rated 6000 MHz settings, or configure timings manually if required. Use the motherboard vendor’s RGB control software or XPG Prime to adjust lighting effects and synchronize with other supported devices. Ensure the system power is off during installation and consult the motherboard manual for slot population recommendations.

Recommendations

For stable operation at rated speeds, update your motherboard BIOS to the latest version, populate recommended DIMM slots as per the motherboard manual, and enable the appropriate memory profile (XMP 3.0 or AMD EXPO). Avoid mixing different memory types or speeds in the same system.