Accesorio para dron DJI O4 Air Unit Pro cable 3 en 1 — cable multiconector para O4 Air Unit Pro

The DJI O4 Air Unit Pro cable 3-in-1 is a multi-connector cable assembly designed for the DJI O4 Air Unit Pro. It combines the power, video and data connections required by the O4 Air Unit Pro into a single cable to simplify installation on compatible drones and FPV rigs while maintaining secure electrical and signal connections during flight.

Advantages

This 3-in-1 cable reduces wiring complexity by integrating multiple signals into one harness, helping to minimize clutter and potential connector failures. The cable is lightweight and compact, suitable for installations where space and weight are limited. It is intended to match the connector layout and electrical requirements of the DJI O4 Air Unit Pro for reliable performance.

Suitable for

• Installing the DJI O4 Air Unit Pro on compatible drones
• FPV rigs that require combined power, video and data connections
• Repair or replacement of existing Air Unit Pro cabling

Key specifications

• Model: Air Unit Series 3-in-1 Cable
• Type: Drone accessory — cable
• MPN: CP.FP.00000238.01
• EAN: 6941565997456
• Shipping box quantity: 1
• Unit net weight: 0.005 kg
• Unit gross weight: 0.007 kg
• Unit box dimensions (L×W×H): 0.135 × 0.09 × 0.005 m
• CnCode: 85444290

How to use

Power down the drone and disconnect any batteries before beginning installation. Route the 3-in-1 cable to the O4 Air Unit Pro and connect each connector to the corresponding port on the Air Unit and the flight controller or power distribution board as required by your frame and wiring layout. Secure the cable with appropriate ties or mounting points to prevent movement during flight and verify all connections before powering on.

Recommendations

Use this cable with the DJI O4 Air Unit Pro and compatible hardware only. Avoid sharp bends and prolonged tension on the connectors; inspect connections periodically and replace the cable if any damage or intermittent signals are observed.