ACT Azul 5 metros cable de red U/UTP CAT6 con protección de lengüeta y conectores RJ45

ACT Blue 5m U/UTP CAT6 Snagless RJ45 patch cable features full copper conductors and meets ANSI/TIA568-C2-1 performance requirements. The cable is U/UTP (unshielded twisted pair) Cat6, has gold-plated RJ45 contacts and a snagless boot design. Compatible with CPR Euroclass: Eca, this 5 m blue patch cable is intended for reliable high-speed data transfer in structured copper networks and is suitable for PoE applications when full copper conductors are required.

Advantages

The cable uses full copper conductors to ensure optimal conductivity and compatibility with Power over Ethernet (PoE). Compliance with ANSI/TIA568-C2-1 and CPR Euroclass Eca provides predictable performance in structured networks. Gold-plated RJ45 contacts improve contact reliability and the snagless design protects the connector clip during installation.

Suitable for

• Connecting switches, routers and patch panels in home and office networks
• High-speed Ethernet connections up to Cat6 performance
• Power over Ethernet (PoE) devices that require full copper conductors
• Short to medium horizontal patching runs (5 m length)

Key specifications

• Brand: ACT
• Model / MPN: IS8605
• EAN: 8716065254655
• Cable type: U/UTP Cat6 (unshielded twisted pair)
• Conductor: full copper
• Length: 5 m
• Connectors: RJ-45 to RJ-45, gold-plated contacts
• Colour: Blue
• Design: snagless boot
• Standards: ANSI/TIA568-C2-1; CPR Euroclass: Eca

How to use

Insert each RJ45 connector into the corresponding ports on network equipment such as switches, routers, patch panels or computers until the connector latches. Route the cable to avoid sharp bends and mechanical strain; use cable management to maintain bend radius and prevent interference. For PoE devices, confirm that both the cable and the powered equipment support the required PoE class.

Recommendations

Use the cable for horizontal and patching connections within the specified 5 m length, avoid exposing it to excessive heat, moisture or mechanical stress, and replace the cable if connectors or conductors are damaged to maintain network reliability.