ACT Azul 75 metros S/FTP CAT6A B2ca PoE++ 100W cable de instalación sólido preensamblado, conector RJ45 macho – macho

The ACT FB0075 is a pre-terminated solid installation network cable, 75 meters long, built to Category 6A S/FTP specification and finished with RJ45 male connectors on both ends. Designed for high-speed 10 Gigabit Ethernet links and certified to ANSI/TIA-568.2-D and ISO/IEC 11801-1, this blue cable uses full copper 23AWG conductors, 50 µin gold-plated RJ45 contacts and IDC termination to ensure reliable signal transmission and long-term mechanical stability. The cable carries a CPR Euroclass B2ca rating for fire performance and supports 4PPoE / PoE++ up to 100 W, making it suitable for installations where both high bandwidth and certified fire behaviour are required.

Advantages

The pre-terminated solid prefab design eliminates on-site termination and reduces installation time by delivering ready-to-connect RJ45 male–male ends; no special tools or advanced termination skills are required. The S/FTP construction and 23AWG full copper cores provide stable high-frequency performance appropriate for 10 Gb/s networks, while IDC contacts are optimized for 4PPoE 100 W to support PoE++ devices reliably. The Euroclass B2ca rating supplies verified fire safety characteristics, allowing use in sensitive or high-risk environments where stricter construction product regulations apply.

Suitable for

When it may not be suitable

This 75 m solid installation cable is intended for fixed, permanent installations and may not be ideal for frequent re-routing, continuous flexing, or patch-panel-side flexible patching where stranded patch cords are preferred. It is pre-terminated as a male–male assembly; if a different connector combination (for example, male–female or female–female) is required, a different product variant should be selected.

Key specifications

How to use

Route the pre-terminated ACT FB0075 cable through cable trays, conduits or cable channels to the desired equipment locations, taking normal bend radius and installation practices for solid installation cables into account. Plug the RJ45 male connectors directly into compatible ports on switches, patch panels or devices that accept a male terminated connection. Ensure proper strain relief at both ends and avoid sharp bends, kinks or prolonged exposure to mechanical stress. For PoE++ applications, verify connected equipment supports 4PPoE and follow local safety and installation regulations for power-over-Ethernet deployments.

What to consider before purchase

Recommendations

For optimal performance, install the ACT FB0075 in permanent cabling runs following recommended bend radius for solid CAT6A cables, secure the cable with appropriate clips or cable ties avoiding over-tightening, and use patch cords at endpoints when flexible connections are needed. Confirm PoE power distribution planning when deploying 100 W devices and maintain documentation of the installed run for future maintenance.