ACT Cable de instalación morado 10m S/FTP CAT6A B2ca PoE++ 100W macizo preterminado, conector RJ45 macho a hembra (FB0110)

This ACT installation cable stands out with its solid-core CAT6A S/FTP construction and B2ca fire rating, making it suitable for permanent runs in buildings where safety and 10 Gigabit performance are required. Unlike typical patch cables, it is pre-terminated with an RJ45 male on one end and an RJ45 female on the other, allowing a clean connection from a wall outlet or patch panel to a device without field termination.

Highlights

• 10-meter pre-terminated CAT6A S/FTP cable with solid bare copper conductors (23 AWG)
• Supports 10GBASE-T up to 500 MHz and PoE++ (IEEE 802.3bt Type 4) up to 100 W
• Low Smoke Zero Halogen (LSZH) jacket with Euroclass B2ca s1a d1 a1 fire rating
• Gold-plated RJ45 male and female connectors, wired to T568B
• Purple jacket for easy identification in structured cabling systems

In daily use

The solid-core design is intended for fixed installations rather than frequent flexing, ensuring stable signal integrity over long distances. The female connector can be mounted in a wall plate or patch panel, while the male end connects directly to a switch, access point, or PoE-powered device. The LSZH jacket reduces toxic smoke in case of fire, and the B2ca rating meets strict European building regulations.

Full specifications

• Cable standard: CAT6A (Category 6A)
• Shielding: S/FTP (Screened Foiled Twisted Pair)
• Length: 10 m
• Colour: Purple
• Conductor: Solid bare copper, 23 AWG
• Jacket: LSZH, Euroclass B2ca s1a d1 a1
• Data rate: 10 Gigabit Ethernet (10GBASE-T)
• Bandwidth: 500 MHz
• PoE: PoE++ (IEEE 802.3bt Type 4), up to 100 W
• Connectors: RJ45 male to RJ45 female, gold-plated (50 µm)
• Wiring: T568B
• Compliance: ISO/IEC 11801, EN 50173, TIA/EIA-568-C.2

Final note

This cable is ideal for professional network installations where performance, safety, and power delivery are critical.