ACT cable de red U/UTP CAT6 blanco 0,5 m con conectores RJ45

The ACT White 0.5m U/UTP CAT6 RJ45 patch cable is a 0.50 m network cable designed for 10/100/1000Base-T(X) Ethernet connections. It features full copper conductors and RJ-45 connectors on both ends, and its U/UTP construction reduces electromagnetic interference while the white jacket provides a neutral appearance suitable for home and office installations. The cable meets CPR Euroclass Eca and is built to comply with ANSI/TIA-568-C.2-1 performance requirements.

Advantages

Full copper conductors ensure reliable signal transmission and compatibility with Power over Ethernet (PoE) devices. The U/UTP design limits external interference, supporting stable high-speed data transfer up to Gigabit Ethernet. Compact 0.5 m length is convenient for short patching runs and tidy cable management in racks, patch panels, and desk setups.

Suitable for

• Short connections between network equipment and patch panels
• Desktop or office workstation cabling
• Connecting switches, routers, and PoE devices within limited distances

Key specifications

• Cable length: 0.5 m
• Standard: U/UTP CAT6
• Connectors: RJ-45 to RJ-45
• Data rate: 10/100/1000Base-T(X)
• Conductor: full copper
• Colour: White
• CPR Euroclass: Eca
• Manufacturer part number (MPN): IB9400
• EAN: 8716065305838

How to use

Plug each RJ-45 connector into the corresponding Ethernet ports on your devices (switch, router, patch panel or network card). Ensure connectors are fully seated until the latch clicks. Use the 0.5 m cable for short patch runs to avoid excess slack; route the cable to prevent sharp bends and mechanical strain on the connectors.

Recommendations

For Power over Ethernet (PoE) deployments, verify that connected devices support the required PoE class and power budget. Avoid running the cable parallel to high-voltage power lines to minimize interference, and replace any cable showing visible damage to maintain network reliability.