ACT Cable de red U/UTP CAT6 naranja de 1,5 m con conectores RJ45 sin protección de lengüeta

ACT Orange 1.5m U/UTP CAT6 patch cable with snagless RJ45 connectors and gold-plated contacts provides full-copper conductors that meet ANSI/TIA568-C2-1 performance requirements. The cable supports high-speed data transfer and Power over Ethernet (PoE) applications while its orange jacket helps easy identification in structured copper data networks. Compatible with CPR Euroclass: Eca.

Advantages

The cable uses full copper conductors for reliable signal transmission and PoE compatibility. Snagless RJ45 connectors and gold-plated contacts reduce wear and ensure stable connections. Compliance with ANSI/TIA standards and CPR Euroclass Eca contributes to predictable, long-term network performance.

Suitable for

• Office and home network connections between switches, routers and patch panels
• PoE devices such as IP cameras, VoIP phones and wireless access points
• Short to medium length horizontal cabling runs and equipment interconnects (1.5 m)

Key specifications

• Brand: ACT
• Model/MPN: IS1551
• Type: U/UTP CAT6 patch cable
• Length: 1.5 m
• Connectors: RJ-45 to RJ-45, snagless
• Conductor: full copper
• Contacts: gold-plated
• Colour: Orange
• Standards: ANSI/TIA568-C2-1 performance, CPR Euroclass Eca
• EAN: 8716065255027

How to use

Plug one RJ45 connector into the network port of your switch, router, patch panel or PoE injector, and the other end into the target device. Ensure connectors fully seat until the latch clicks. Route the cable without sharp bends and avoid tight bends near the connectors to maintain signal integrity. Use the 1.5 m length for short interconnects or workspace connections.

Recommendations

For PoE devices, verify that both the powered device and the power sourcing equipment support the required PoE class. Avoid running the cable alongside high-voltage power lines to reduce interference and maintain optimal performance.