ACT Gris 25 metros LSZH SFTP CAT6A Cable de conexión con conectores RJ45

The ACT Grey 25 meter LSZH SFTP CAT6A patch cable (model IB4025) is a 25 m network cable with S/FTP shielding and RJ-45 connectors at both ends. It conforms to Cat6a standards and supports high-speed data transmission with bandwidths up to 500 MHz. The jacket is made of LSZH (Low Smoke Zero Halogen) material and is compatible with CPR Euroclass Eca, reducing the release of smoke and halogenated toxic gases in case of fire.

Advantages

The S/FTP construction provides enhanced protection against electromagnetic interference and crosstalk, ensuring stable connections and consistent signal quality. The LSZH jacket limits smoke and toxic emissions in confined or poorly ventilated spaces. Standard RJ-45 terminations make the cable compatible with common network equipment, while Cat6a specification supports demanding data applications.

Suitable for

• Office and data center horizontal and patch cabling
• Indoor environments with ventilation constraints (trains, aircraft interiors, vehicles)
• High-speed Ethernet links up to Cat6a performance

Key specifications

• Brand: ACT
• Model / MPN: IB4025
• EAN: 8716065307122
• Cable length: 25 m
• Shielding: S/FTP (overall braid + foil per pair)
• Connector type: RJ-45 to RJ-45
• Category: Cat6a
• Bandwidth: up to 500 MHz
• Jacket material: LSZH (Low Smoke Zero Halogen)
• CPR Euroclass: Eca
• Colour: Grey

How to use

Install the cable between compatible RJ-45 ports on network devices such as switches, routers, patch panels and network interfaces. Route the cable to avoid sharp bends and mechanical stress; maintain bend radius recommended for Cat6a cables to preserve performance. For permanent installations, secure the cable with appropriate clips or cable management accessories and avoid running parallel to high-voltage power lines to reduce interference.

Recommendations

Use this LSZH S/FTP Cat6a patch cable for indoor patching and horizontal runs where reduced smoke and halogen emissions are required. Verify connector seating and test links after installation using a network cable tester to confirm performance up to Cat6a specifications.