ACT marfil 1 metro U/UTP CAT5E cable de red con conectores RJ45

The ACT Ivory 1 meter U/UTP CAT5E patch cable with RJ45 connectors is a 1 m network cable designed for standard Ethernet connections. It uses full copper AWG#24 conductors and RJ-45 plugs with 50µ gold plating to ensure reliable signal transmission and corrosion resistance. The cable is 1 meter long, finished in ivory color, and is intended for connecting routers, switches, computers and other Ethernet-enabled devices. ACT specifications have been independently verified and each cable is 100% tested.

Advantages

The cable combines full copper AWG#24 wiring and 50µ gold-plated RJ-45 contacts for stable conductivity and reduced signal loss. Individual testing of each unit ensures consistent quality, while independent certification confirms compliance with ACT specifications. The 1 m length simplifies cable routing and the ivory colour integrates unobtrusively into most environments.

Suitable for (tasks / use cases)

• Connecting routers to switches
• Linking computers to local networks
• Patch panel to switch connections in small racks
• Home and office Ethernet wiring where a 1 m cable is sufficient

Key specifications

• Standard: CAT5E (U/UTP)
• Cable length: 1 m
• Conductor: full copper, AWG#24
• Connectors: RJ-45 to RJ-45
• Contact plating: 50µ gold
• Colour: Ivory
• Testing: 100% tested; ACT specifications verified by independent institute

How to use

Insert each RJ-45 connector firmly into the network ports of the devices to be connected until the latch clicks. Ensure devices are powered off or follow hot-plugging safety procedures if applicable. Route the cable to avoid tight bends and sharp edges, and secure it with clips or cable ties if required to prevent strain on the connectors.

Recommendations

For best performance, keep cable runs within recommended Ethernet lengths for CAT5E and avoid running parallel to power cables to reduce electromagnetic interference. Replace the cable if connectors or conductors show signs of damage.