ACT marfil 15 m SFTP CAT6A cable de red con protección de pestaña y conectores RJ45

The ACT Ivory 15 meter SFTP CAT6A patch cable FB6015 is a shielded Ethernet cable designed for high-speed network connections up to CAT6A performance. It uses full copper AWG#26 conductors, S/FTP shielding to reduce electromagnetic interference, and 50µ gold-plated RJ-45 contacts for reliable signal transmission. The cable comes with snagless RJ-45 connectors and an ivory jacket for a discreet appearance in office or home installations.

Advantages

SFTP construction and individual pair shielding improve noise rejection and support stable high-bandwidth data transfer. Full copper AWG#26 conductors ensure consistent conductivity and lower attenuation compared with copper-clad alternatives. Gold-plated 50µ RJ-45 contacts provide corrosion resistance and reliable mating, while the snagless connector design protects the tab during installation and maintenance.

Suitable for

• Wired Ethernet connections for desktops, servers and switches
• Office and home network installations requiring CAT6A performance
• High-bandwidth applications such as video streaming and large file transfers
• Environments where reduced EMI/RFI is important

Key specifications

• Standard: CAT6A (S/FTP)
• Cable length: 15 m
• Conductor: full copper AWG#26
• Shielding: S/FTP (overall braid + foil around pairs)
• Contacts: 50µ gold-plated RJ-45
• Connectors: snagless RJ-45 to RJ-45
• Colour: Ivory
• Brand: ACT, MPN: FB6015, EAN: 8716065276480

How to use

Connect one RJ-45 end to your network device (router, switch, or computer) and the other end to the corresponding port on the remote device. Ensure connectors are fully seated until the latch engages. Route the cable to avoid tight bends, sharp edges, and sources of strong interference. For fixed installations, label both ends to simplify future maintenance.

Recommendations

Use the ACT SFTP CAT6A patch cable where CAT6A performance and reduced electromagnetic interference are required. Avoid kinking the cable and keep bend radius within manufacturer guidelines; do not exceed rated temperature ranges for permanent installations.