ACT Naranja 1 m cable de red U/UTP CAT6 sin lengüeta con conectores RJ45

The ACT Orange 1 meter U/UTP CAT6 patch cable with snagless RJ45 connectors provides a reliable copper link for Ethernet networks. Constructed with full copper conductors and gold-plated contacts, the cable meets ANSI/TIA568-C2-1 performance requirements and is compatible with CPR Euroclass Eca. Its 1 m length and bright orange jacket make it suitable for organized home and office installations where clear cable identification is needed.

Advantages

This CAT6 U/UTP patch cable uses full copper conductors to ensure stable signal transmission and compatibility with Power over Ethernet (PoE) devices. Snagless RJ45 connectors protect the plug latch during installation, and gold-plated contacts improve corrosion resistance and contact reliability. Compliance with ANSI/TIA568-C2-1 and CPR Euroclass Eca provides predictable performance in structured copper networks.

Suitable for

• Connecting switches, routers and patch panels in office networks
• Home networking between routers, PCs and NAS devices
• PoE devices such as IP cameras, VoIP phones and access points
• Short-distance horizontal cabling and patching in data cabinets

Key specifications

• Standard: U/UTP CAT6
• Length: 1 m
• Conductors: full copper
• Connectors: RJ-45 to RJ-45, snagless
• Contacts: gold-plated
• Color: Orange
• Performance: meets ANSI/TIA568-C2-1
• CPR Euroclass: Eca

How to use

Plug one RJ45 connector into the network port of your device and the other into the corresponding switch, router or patch panel port. Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid sharp bends and mechanical strain; use cable management elements in racks or on desks to maintain organized runs. For PoE-powered devices, confirm that the switch or injector provides the required power class.

Recommendations

For optimal long-term performance, avoid running the cable parallel to high-voltage power lines, maintain bend radii larger than the cable diameter, and replace any cable with visible damage. Use the orange color to mark specific circuits or device groups for easier maintenance.