ACT rojo 15 m cable de red U/UTP CAT6 con protección de pestaña y conectores RJ45

ACT patch cable Red 15 meter U/UTP CAT6 snagless with RJ45 connectors provides a 15 m connection cable for Ethernet networks. The cable uses full copper conductors, meets ANSI/TIA568-C2-1 performance requirements and is compatible with CPR Euroclass Eca. Its U/UTP construction reduces external interference while gold-plated RJ45 contacts improve signal transmission.

Advantages

The ACT 15 m CAT6 patch cable offers full copper conductors suitable for PoE applications, compliance with recognized wiring standards, and a snagless design that protects the connector latch during routing. U/UTP shielding and gold-plated contacts contribute to stable high-speed data transfer over longer cable runs.

Suitable for

• Cable connections between switches, patch panels and network devices
• Power over Ethernet (PoE) deployments
• Office, server room and structured cabling installations
• Temporary or permanent network extensions where a 15 m length is required

Key specifications

• Brand: ACT
• Model / MPN: IS8515
• Length: 15 m
• Category: CAT6 U/UTP
• Connectors: RJ-45 to RJ-45, gold-plated contacts
• Conductor: solid full copper
• Colour: Red
• CPR Euroclass: Eca
• EAN: 8716065254587

How to use

Connect one RJ45 connector to a network device (switch, router, patch panel or NIC) and the other RJ45 connector to the corresponding port. Ensure connectors are fully inserted until the latch clicks. Route the cable without sharp bends and avoid placing it under mechanical stress. For PoE devices, verify that the switch or injector provides the appropriate power class.

Recommendations

For best performance, avoid running the cable in parallel with high-voltage power lines and keep bend radius greater than four times the cable diameter. Replace the cable if outer insulation or connectors are damaged. Use the snagless feature when pulling through cable management channels to prevent latch damage.