ACT Rosa cable de red U/UTP CAT6A de 7 metros con conectores RJ45

ACT Pink 7 meter U/UTP CAT6A IB7307 patch cable is a seven-metre Ethernet cable with full copper conductors and RJ-45 connectors with gold plating. It meets ANSI/TIA568-C2-1 performance requirements and is compatible with CPR Euroclass Eca. The U/UTP CAT6A design supports high-speed data transmission and reduces electromagnetic interference, making it suitable for structured copper networks in homes and offices. The pink colour identifies the cable visually for easier management.

Advantages

The cable uses full copper conductors to ensure optimal conductivity and reliable signal transfer, including for Power over Ethernet (PoE) applications. Gold-plated RJ-45 contacts improve contact quality and corrosion resistance. Compliance with ANSI/TIA568-C2-1 and CPR Euroclass Eca provides assurance of standardized performance and material safety. U/UTP CAT6A construction offers improved performance for Gigabit and higher-speed networking.

Suitable for

• Structured copper LAN installations in homes and offices
• Gigabit Ethernet and 10/100/1000Base-T(X) networks
• Power over Ethernet (PoE) powered devices
• Color-coded cable management and identification

Key specifications

• Length: 7 m
• Type: U/UTP CAT6A patch cable
• Conductors: Full copper
• Connectors: RJ-45 to RJ-45 with gold plating
• Standard compliance: ANSI/TIA568-C2-1
• CPR Euroclass: Eca
• Supported cabling technology: 10/100/1000Base-T(X)
• Color: Pink

How to use

Connect one RJ-45 end of the ACT Pink CAT6A patch cable to the network port of a switch, router or patch panel and connect the other end to the network device such as a computer, IP camera or access point. Ensure plugs are fully inserted until the latch clicks and avoid sharp bends or kinks in the cable to maintain performance. For PoE devices, confirm that both the switch and the powered device support the required PoE class and power budget.

Recommendations

To preserve signal integrity, route the cable away from strong sources of electromagnetic interference and maintain bend radii recommended by networking equipment manufacturers. Replace damaged cables and avoid using cables with non-copper conductors for PoE applications.