ACT Verde 2 metros LSZH U/UTP CAT6 Datacenter Slimline cable de red con conectores RJ45

The ACT Green 2 meter LSZH U/UTP CAT6 patch cable is a slimline datacenter Ethernet cable with a 2 m length and snagless RJ45 connectors. Its reduced conductor diameter and overall cable thickness provide a smaller bending radius and improved airflow in racks and cabinets. The cable uses U/UTP construction and LSZH jacket material, suitable for installations where low-smoke, halogen-free behavior is required.

Advantages

Slimline CAT6 construction yields a smaller outer diameter compared with regular CAT6 patch cords, enabling denser cable routing and better cabinet airflow. Snagless RJ45 connectors protect the plug clip during installation. The LSZH jacket reduces harmful emissions in confined spaces. The U/UTP design minimizes external interference while remaining suitable for typical datacenter patching.

Suitable for

• Patch panels and switch ports in datacenter cabinets
• High-density cabling runs where space and airflow are limited
• Environments requiring low-smoke, halogen-free cable jackets

Key specifications

• Category: CAT6 (U/UTP)
• Length: 2 meters
• Conductor gauge: 28 AWG (slimline)
• Outer diameter: approximately 3.8 mm (slimline)
• Connector: RJ45 snagless
• Jacket material: LSZH (low smoke, zero halogen)

How to use

Connect the snagless RJ45 plug to the device or patch panel port until the clip locks. Route the cable through the rack or cabinet, respecting the reduced bending radius of the slimline cable. For long permanent links or extended horizontal runs, consider the higher attenuation of 28 AWG conductors and verify channel loss against system requirements.

Recommendations

Use these slimline CAT6 patch cables for short interconnects in high-density datacenter environments. Because 28 AWG conductors increase attenuation—especially at higher frequencies—keep permanent link and channel lengths shorter than with standard 24 AWG cords and follow current guidelines for temperature rise and bundle sizes in PoE deployments (recommend limiting bundles to about 24 cables to reduce temperature increase).