ACT verde cable de conexión Slimline U/FTP CAT6A LSZH para centro de datos de 0,5 m snagless con conectores RJ45

The ACT Green 0.5m LSZH U/FTP CAT6A patch cable is a slimline Ethernet cable designed for high-speed data transmission in data centers and densely packed networking cabinets. With a 3.8 mm diameter, U/FTP shielding and snagless RJ45 connectors with gold-plated contacts, the cable provides reliable connectivity while allowing improved airflow and easier routing compared with standard CAT6A patch cords.

Advantages

The slim 3.8 mm diameter reduces cable bulk and enables a smaller bending radius, which helps maintain better airflow in cabinets and simplifies cable management. U/FTP shielding reduces susceptibility to electromagnetic interference. Gold-plated contacts on the RJ45 connectors provide stable signal contact. The LSZH jacket limits smoke and toxic emissions in case of fire.

Suitable for

• High-density data center patching
• Short permanent links where space is limited
• Structured cabling installations requiring U/FTP shielding
• Environments needing LSZH-rated cabling

Key specifications

• Product: Patch Cable ACT Green 0.5m LSZH U/FTP CAT6A
• Length: 0.5 m
• Cable type: CAT6A U/FTP slimline
• Diameter: approx. 3.8 mm (slimline)
• Connectors: RJ-45 to RJ-45, snagless, gold-plated contacts
• Jacket: LSZH
• Colour: Green
• MPN / EAN: DC7700 / 8716065442175

How to use

Connect one RJ45 end to a network port on your switch, patch panel or device and the other end to the corresponding port. Route the slimline cable through cable managers or ducting as required; the smaller diameter and lower bending radius make it suitable for tight paths. For best performance, keep patch cable lengths short and avoid unnecessary bundling where possible.

Recommendations

ACT recommends using this 32 AWG slimline cable for shorter permanent link lengths compared with standard 24 AWG patch cords due to higher attenuation at higher frequencies. For PoE applications, limit bundle sizes to a maximum of 24 cables to prevent excessive temperature rise; ANSI TSB-184-A specifies that temperature increase for the center cable should remain under 15°C above ambient.