Amoladora angular Metabo W 13-125 Quick

The Metabo W 13-125 Quick angle grinder is a compact, mains-powered tool designed for general grinding and cutting tasks. It is equipped with a 1350 W motor delivering a maximum idle speed of 11,000 RPM and an output power of 830 W. The grinder accepts 125 mm (12.5 cm) discs, produces 3.4 N·m of torque and weighs approximately 2.4 kg. The housing and control elements are finished in Metabo’s green and black colour scheme, providing a familiar ergonomic layout for steady handling during use.

Advantages

The tool combines a high-speed motor with a modest overall weight to facilitate extended periods of use with reduced operator fatigue. Its 125 mm disc size offers a balance between cutting depth and manoeuvrability for a wide range of materials. The specified torque and output power support efficient material removal while the rugged construction is intended to withstand workshop and site conditions.

Suitable for

• Grinding and smoothing metal surfaces
• Cutting metal pipes and profiles
• Removing rust and old paint with abrasive discs or wire brushes
• Shaping and trimming masonry or concrete with appropriate discs
• Preparing weld seams and deburring edges

Key specifications

• Motor power (input): 1350 W
• Rated output power: 830 W
• Maximum no-load speed: 11,000 RPM
• Disc diameter: 125 mm (12.5 cm)
• Torque: 3.4 N·m
• Weight: 2.4 kg
• Power source: AC mains
• Colour: green and black

How to use

Fit a compatible 125 mm disc or accessory and secure the protective guard according to the manufacturer’s instructions before connecting the tool to the power supply. Hold the grinder with both hands, using the side handle for additional control, and allow the motor to reach full speed before contacting the workpiece. Move the disc steadily across the surface using light, even pressure. Release the trigger and allow the disc to stop completely before setting the tool down or changing accessories.

Recommendations

Use appropriate personal protective equipment, including eye protection, hearing protection and gloves. Select discs rated for the grinder’s maximum speed and for the material being worked on. Maintain firm control of the tool, avoid side loads on cutting discs, and do not exceed declared operating parameters. Regularly inspect the tool, power cable and accessories for wear or damage and replace as necessary.