Amoladora angular YATO YT-82826, 18V Li-Ion 2Ah, disco de 125 mm, 10.000 rpm, rosca M14, carcasa de protección ajustable sin herramientas

The Angle Grinder Yato YT-82826 is a compact, battery-powered grinder designed for portable grinding and light cutting tasks. It uses a 12.5 cm (125 mm) grinding disc and runs at a maximum idle speed of 10,000 RPM. The tool weighs approximately 1.5 kg and is driven by a 60 W lithium-ion battery, offering cordless mobility for use in locations without mains power. Built-in overheating protection helps safeguard the motor during extended use. The spindle bore diameter is 2.22 cm, compatible with standard 125 mm discs that fit this bore size.

Advantages

The grinder combines a small footprint with a relatively high no-load speed, enabling efficient material removal and finishing in confined spaces. Its low weight improves handling and reduces user fatigue during prolonged tasks. The lithium-ion battery supply allows for cordless operation and faster setup. Overheating protection increases operational safety and prolongs tool life. The red and black housing provides visual contrast for easy identification on a busy job site.

Suitable for

• Light grinding and deburring of metal surfaces
• Cutting thin metal sheets, bolts and rebar
• Surface preparation and rust removal on small areas
• Sanding and polishing with appropriate 125 mm accessories
• Portable jobs where mains power is unavailable

Key specifications

• Disc diameter: 12.5 cm (125 mm)
• Maximum no-load speed: 10,000 RPM
• Power source: 60 W lithium-ion battery
• Weight: 1.5 kg
• Spindle bore (bore size): 2.22 cm
• Product colour: Red and Black
• Built-in overheating protection

How to use

Before first use, ensure the lithium-ion battery is fully charged and properly inserted according to the manufacturer's instructions. Fit a suitable 125 mm disc that matches the spindle bore of 2.22 cm and tighten the flange securely. Hold the grinder with both hands, position the guard between the disc and your body, and start the tool while maintaining a firm grip. Allow the tool to reach full speed before engaging the workpiece, and use steady, controlled motions for grinding or cutting. After use, switch the tool off and wait for the disc to stop before setting it down; remove the battery for storage or transport.

Recommendations

Use appropriate personal protective equipment such as eye protection, hearing protection and gloves; select discs rated for the intended material and RPM; avoid prolonged continuous use to prevent overheating and allow cooling periods as necessary.