Antipop para micrófono Omnitronic 6000624N negro — protección para reducir las plosivas

The Omnitronic microphone pop filter model 6000624N in black is a shield designed to reduce plosive sounds when recording vocals or using a microphone live. Mounted in front of a microphone, this pop filter creates a barrier that disperses air bursts from consonants such as "p" and "b", helping to prevent sudden low-frequency spikes and breath noise. The product is adapted for use in studios, podcasting setups, streaming desks and stage applications where clearer vocal capture is needed.

Advantages

The pop filter provides effective plosive reduction while maintaining natural vocal tone by diffusing air without significantly affecting high-frequency detail. Its black finish is unobtrusive in video and onstage environments. The design allows straightforward attachment and positioning in front of most handheld and mounted microphones, promoting consistent recording quality and reduced need for post-processing to remove plosive artifacts.

Suitable for

Key specifications

How to use

Position the pop filter between the vocalist and the microphone so that the filter is aligned with the microphone capsule and the performer’s mouth. Leave a small gap of a few centimeters between the filter and the microphone to allow sound to pass while dispersing airflow. Adjust the angle and height of the shield for optimal coverage of plosive sources; check levels and listen for reduced low-frequency pops during a test recording or soundcheck. Secure the filter so it stays in place during performance or recording.

Recommendations

For consistent results, combine the pop filter with proper mic technique: maintain a steady distance from the microphone (typically 5–15 cm), angle the microphone slightly off-axis from the mouth, and perform a brief pre-session test to set gain levels and confirm plosive reduction.