AOC SFP28 BlueOptics BO272703Q10M cable óptico activo de 10 m, CBO SFP28-AOC-10M-MT-BO

Active optical cable AOC SFP28 BlueOptics BO272703Q10M 10M by BlueOptics provides a 10-meter fiber-based direct connection for SFP28 ports. The CBO SFP28-AOC-10M-MT-BO form factor integrates transceiver functions into a single cable assembly, enabling high-speed 25 Gbps links between servers, switches and other SFP28-equipped network devices. Designed for data center and rack environments, this AOC reduces the number of separate components needed for short to medium runs while lowering power consumption compared with discrete transceivers plus patch cords.

Advantages

The AOC combines optical transceiver and fiber cable into a single pre-terminated unit, eliminating the need for separate pluggable modules and patch cables. Its 10 m length offers flexibility for typical rack-to-rack and row cabling without splicing or field termination. Because the optical interfaces are integrated, the cable typically consumes less power and simplifies inventory management. The BlueOptics AOC maintains signal integrity across the full link distance and supports low-latency traffic suitable for high-performance networking tasks.

Suitable for

• Server-to-switch 25 Gbps interconnects in data centers
• Switch-to-switch aggregation and leaf-spine links
• Top-of-rack and middle-of-row cabling within equipment racks
• Environments requiring reduced power and simplified cable management

Key specifications

• Connector type: SFP28 compatible plugs at both ends
• Length: 10 meters
• Transmission mode: multimode optical link implemented as an active optical cable
• Data rate: supports 25 Gbps per lane (SFP28 standard)
• Latency: designed for low-latency connections typical of direct optical links
• Power consumption: lower than equivalent configurations using separate transceivers and patch cords
• Form factor: integrated transceiver-cable assembly for direct insertion into SFP28 ports

How to use

Insert each SFP28-compatible end of the cable into the corresponding SFP28 port on your devices until the latch engages. Ensure both devices are powered and configured for the appropriate 25 Gbps interface settings. Monitor link status through your equipment management interfaces and verify that interfaces come up at the expected speed. When removing the cable, disengage the latch before gently pulling the connector to avoid damaging the port.

Recommendations

Use the AOC for in-rack or short row runs up to 10 meters to maintain optimal signal quality and low latency. Avoid tight bends and excessive pulling force on the cable; follow manufacturer bend-radius guidelines. Verify compatibility with switch and server vendors where required and test link performance after installation to confirm expected throughput and latency.