AOC CBO SFP-AOC-10G-5M Broadcom cable óptico activo, 10 Gbit/s, 5 m

AOC CBO SFP-AOC-10G-5M Broadcom active optical cable, 10 Gbps, 5 m is a Broadcom-compatible SFP+ active optical cable (AOC) designed for short-range 10 Gigabit Ethernet connections. The 5‑metre cable integrates optical transceivers in a fixed assembly, enabling direct SFP+ to SFP+ links between servers, switches and storage equipment without separate hot-pluggable transceivers. It supports 10 Gbps line rate with low latency and provides electrical isolation to reduce electromagnetic interference in dense rack environments.

Advantages

The active optical design delivers consistent 10 Gbps throughput over a 5 m reach while keeping connector density and cable bulk lower than equivalent copper assemblies. Compatibility with Broadcom SFP+ implementations simplifies deployment in many data centre switches and network adapters. Integrated optics eliminate the need to buy and install separate transceivers, reducing part management and potential mismatch issues. Optical transmission affords electrical isolation and lower susceptibility to crosstalk and ground-loop problems common in tightly packed racks.

Suitable for

• Short-range 10 Gigabit links between servers and top-of-rack or spine switches
• Interconnects for storage arrays and host bus adapters supporting SFP+
• High-density cabling in data centres, network closets and equipment cabinets
• Low-latency connections in virtualised environments and clustered systems

Key specifications

• Connector type: SFP+ to SFP+
• Data rate: 10 Gbps (full duplex)
• Length: 5 metres
• Type: Active optical cable with integrated transceivers
• Compatibility: Broadcom-compatible SFP+ host implementations
• Transmission medium: Multimode optical link within cable assembly
• Typical use: Short-range data centre and network interconnects

How to use

Install the cable by inserting each SFP+ connector into the corresponding SFP+ slot on the devices to be connected, ensuring that the link modules seat fully and the retention latches engage. Power on the devices and verify link status through device LEDs or management interfaces. No external transceivers or additional fibre patching is required; the fixed AOC assembly delivers a ready-to-use optical link. For equipment with vendor port locking or software-based port validation, confirm compatibility and enable the port if necessary.

Recommendations

Route the cable to avoid tight bends and mechanical strain; follow the manufacturer’s minimum bend radius guidelines. Keep optical connectors and SFP+ cages free of dust and debris when inserting the cable. For redundancy, plan link aggregation or alternate paths rather than relying on a single AOC for critical uplinks.