AOC SFP+ CBO SFP-AOC-10G-50M Palo Alto Networks cable óptico activo 10 Gbit/s, 50 m

The AOC SFP+ CBO SFP-AOC-10G-50M Palo Alto Networks 10Gbps Active Optical Cable, 50 m is an SFP+ form-factor active optical cable designed for short-reach 10 Gbps connections. It connects SFP+ ports on switches, routers and servers over multimode fiber at a distance of up to 50 meters, delivering low-latency, high-throughput performance with reduced electromagnetic interference compared to copper cabling. The cable is compatible with Palo Alto Networks SFP+ ports and follows standard SFP+ electrical and optical interfaces to ensure straightforward deployment in data center and enterprise networking environments.

Advantages

This active optical cable provides 10 Gbps bandwidth over a 50 m multimode link while keeping power consumption and latency low. The SFP+ form factor allows direct insertion into compatible transceiver slots without additional transceivers, simplifying installation and reducing rack space usage. Optical transmission reduces susceptibility to electromagnetic interference and cross-talk, and the lightweight, flexible cable design simplifies cable management in dense rack environments.

Suitable for

• Short-reach intra-rack and inter-rack connections in data centers
• High-throughput links between switches, routers and servers
• Enterprise network uplinks and aggregation paths
• Environments where reduced EMI and simplified cabling are required

Key specifications

• Form factor: SFP+ active optical cable
• Maximum data rate: 10 Gbps
• Maximum link length: 50 meters over multimode fiber
• Connector type: SFP+ plug on both ends
• Transmission type: Active optical (multimode)
• Typical application: Short-range 10Gb links for data centers and enterprise networks

How to use

Insert each SFP+ connector into the corresponding SFP+ port on your network devices until it latches. Ensure both device ports support SFP+ AOC modules and are powered off or allow hot-plugging per device documentation. After insertion, verify link status through the device management interface and confirm negotiated 10 Gbps operation. Route the cable to avoid tight bends and secure it to prevent strain on the connectors; maintain the minimum bend radius recommended by the manufacturer to preserve signal integrity.

Recommendations

Use this cable for reliable short-distance 10 Gbps connections inside racks or between adjacent racks. Avoid exposure to excessive mechanical stress, sharp bends, or liquids, and follow your equipment vendor’s compatibility and warranty guidelines when deploying SFP+ active optical cables.