Cable AOC CBO QSFP-100G-AOC-10M 10 m – cable de conexión directa óptico activo QSFP+ 100G

The AOC cable CBO QSFP-100G-AOC-10M is a 10-metre active optical QSFP+ direct-attach cable designed for high-density networking environments. It provides 100 Gbps full-duplex connectivity using QSFP+ interfaces and is intended for short- to medium-range links between servers, switches and other data centre equipment. The cable combines optical transmission with integrated transceivers to deliver low latency and reduced power consumption compared with equivalent multi-lane copper assemblies.

Advantages

This active optical cable offers high bandwidth and signal integrity over a 10 m reach while eliminating the need for separate optical transceivers and patch cords. Its QSFP+ connectivity enables straightforward plug-and-play installation in compatible ports, reduces rack congestion through a thin, flexible cable profile, and lowers heat output and power draw relative to multiple copper lanes. The integrated optics simplify cabling management for dense topologies.

Suitable for

• 100G links between top-of-rack switches and aggregation switches in data centres
• High-performance server-to-switch interconnects
• Connections within switch stacks and modular chassis systems
• Short- to medium-distance spine-leaf architectures

Key specifications

• Connector type: QSFP+ (active optical)
• Data rate: 100 Gbps full-duplex
• Length: 10 metres
• Cable type: Active optical cable (AOC) with integrated transceivers
• Latency: low, suitable for low-latency environments
• Form factor: compact, flexible jacket for high-density deployments

How to use

Install the cable by inserting the QSFP+ plugs into matching QSFP+ ports on networking equipment; the integrated optics remove the need for separate SFP/QSFP transceivers. Ensure both devices support 100G operation and that port firmware or configuration matches the intended link mode. Route the cable to avoid tight bends and mechanical stress, secure it to prevent movement, and verify link status via device LEDs or management interfaces after connection.

Recommendations

Use this 10 m active optical QSFP+ cable in controlled data centre environments where 100G throughput, low latency and compact cabling are required. Maintain minimum bend radius specified by the manufacturer, avoid exposure to liquids or excessive heat, and confirm compatibility with the installed QSFP+ ports and switch vendor interoperability lists before deployment.