Cable AOC CBO QSFP-100G-D-AOC-10M 10 m — Cable óptico activo QSFP+ 100G, 10 metros

Active Optical Cable CBO QSFP-100G-D-AOC-10M is a 10-meter QSFP+ 100G direct-attach solution designed for low-latency, high-bandwidth interconnects. The cable integrates QSFP+ connectors on both ends with optical fiber transmission to deliver 100 Gbps links between switches, routers and servers without separate transceivers. Intended for use in data centers, high-performance computing clusters and enterprise network racks, the cable offers a predictable optical link over a longer reach than copper direct-attach options.

Advantages

The 10 m QSFP+ active optical cable provides high aggregate bandwidth and reduced electromagnetic interference compared with copper alternatives. Integrated optical components simplify installation because no additional transceivers are required, reducing component count and potential points of failure. Its design supports low latency and stable signal integrity for demanding workloads and allows efficient cable management in rack environments.

Suitable for

• Inter-switch connections in data center topologies
• Server-to-switch links in high-performance computing and virtualization clusters
• Router interconnects requiring 100 Gbps links over intermediate rack distances

Key specifications

• Connector type: QSFP+ on both ends
• Data rate: 100 Gbps aggregate
• Cable type: active optical cable (AOC) with integrated optical transceivers
• Length: 10 meters
• Typical use: short to medium reach within data center and enterprise racks
• Signal medium: multimode/mode-optimized optical fiber within the assembly

How to use

Install the cable by inserting each QSFP+ connector into the corresponding QSFP+ port on switches, routers or servers; ensure port compatibility and that the host ports support QSFP+ AOC assemblies. Secure the cable routing in the rack to avoid tight bends or stress at the connector. No separate transceiver modules are required, so after physical connection devices should negotiate link parameters and reach operational link state according to equipment firmware and management settings.

Recommendations

Verify that network devices support QSFP+ AOC assemblies and compatible 100 Gbps lanes before deployment. Maintain a minimum bend radius as specified by the manufacturer and avoid repeated flexing near connectors. For long-term reliability, route and secure the 10 m cable to prevent strain and inspect connector endcaps for contamination prior to insertion.