Cable AOC CBO SFP-AOC-10G-7M cable óptico activo 10 Gbps, 7 m

The AOC Cable CBO SFP-AOC-10G-7M Active Optical Cable 10 Gbps, 7 m is a factory-terminated SFP+ active optical link designed for direct connections between SFP+ ports. It provides a 10 Gbps full-duplex data channel over a 7-meter multimode optical assembly, offering electrical isolation and reduced electromagnetic interference compared with copper cabling. The cable is intended for short to medium reach connections inside data centres, between server racks, and for switching equipment interconnects where consistent 10 Gigabit Ethernet performance is required.

Advantages

This active optical cable combines low latency 10 Gbps throughput with lightweight construction and improved thermal behaviour compared to equivalent copper solutions. The optical medium eliminates ground loop issues and lowers susceptibility to EMI, while the factory-terminated SFP+ connectors ensure plug-and-play compatibility with standard SFP+ ports. The fixed 7 m length simplifies cable management in rack environments and reduces clutter without sacrificing bandwidth.

Suitable for

• Server-to-switch and switch-to-switch links in data centres
• Inter-rack connections where a 7 m reach is required
• High-density rack deployments seeking reduced cable weight and better airflow
• Environments requiring electrical isolation to avoid ground loops

Key specifications

• Data rate: 10 Gbps full-duplex
• Length: 7 metres
• Interface type: SFP+ form-factor, active optical
• Medium: optical fiber (multimode active optical assembly)
• Typical use: short to medium reach within racks and between adjacent racks
• Latency: low propagation delay suitable for network and storage traffic
• Electrical characteristics: provides electrical isolation between connected devices

How to use

Install each SFP+ connector into the corresponding SFP+ port of the devices to be linked while the equipment is powered down or according to the device vendor’s hot-plug guidance. Ensure connectors are clean and free of dust before insertion. Route the cable through rack channels or cable managers to avoid sharp bends; maintain the manufacturer’s minimum bend radius. After physical connection, verify link status and speed in switch or server management interfaces and confirm network configuration such as VLANs and MTU settings as required.

Recommendations

Store and handle the active optical cable by the connector housings, avoid kinking or crushing the fiber assembly, and keep the connector dust caps in place when not in use. Use the fixed 7 m length to plan tidy cable runs and improve rack airflow. For compatibility, consult the equipment documentation for supported SFP+ modules and transceivers.