Cable AOC SFP+ CBO Zyxel SFP-AOC-10G-5M 10G, 5 m

The SFP+ AOC cable CBO Zyxel SFP-AOC-10G-5M 10G, 5 m is an active optical cable in SFP+ form factor designed for short-reach 10 Gbit/s interconnects. It provides a direct fiber-optic connection between devices with SFP+ ports over a 5-meter link, enabling low-latency, high-bandwidth data transmission while reducing susceptibility to electromagnetic interference. The cable is intended for deployment in data centers, server rooms and networking racks where compact, easy-to-install connections are required.

Advantages

This AOC offers a 10 Gbit/s data rate over a fixed 5 m optical link in a hot-pluggable SFP+ module format, combining the performance of fiber with the simplicity of a direct attach cable. The active optical design ensures low latency and stable throughput while eliminating the need for separate transceivers and patch cords. The compact SFP+ housing is compatible with devices that accept SFP+ modules, and optical signaling provides immunity to electromagnetic interference and crosstalk common in copper cabling.

Suitable for

• Short-reach connections between network switches supporting SFP+ ports
• Server-to-switch or server-to-storage links in racks and cabinets
• Top-of-rack and leaf-spine architectures in small and medium data centers
• High-density cabling scenarios where space and airflow considerations are important

Key specifications

• Form factor: SFP+ active optical cable
• Nominal data rate: 10 Gbit/s
• Link length: 5 meters
• Transmission medium: multimode optical fiber with active optical electronics
• Latency: low, suitable for high-performance switching and storage interconnects
• Connector type: SFP+ plug-in modules on both ends
• Electrical characteristics: low power consumption typical for SFP+ AOC assemblies

How to use

Install the SFP+ AOC by inserting each SFP+ plug into the corresponding SFP+ port on the network devices until the module latches. Ensure that both devices support 10G SFP+ signaling and that ports are configured for the intended link speed. No additional transceivers or patch fibers are required; the cable pair is factory-assembled and polarity-correct. Monitor link status via your device management interface and verify that LEDs or software indicate an active 10 Gbit/s connection.

Recommendations

For reliable operation, avoid exceeding the specified bending radius of the cable and keep the cable free from sharp kinks or tight folds. Use in environments within the equipment's recommended temperature range and ensure firmware or driver compatibility on networking equipment if vendor-specific compatibility lists are observed.