Cable DAC CBO QSFP28-DAC-1M 1m cobre pasivo 100G

Direct Attach Copper (DAC) cable CBO QSFP28-DAC-1M is a 1-meter passive copper interconnect engineered for 100G connectivity using QSFP28 interfaces. It offers a straightforward, low-latency link for short-reach connections in data centers and high-density network racks, enabling direct connections between switches, routers and servers without the need for optical transceivers. The cable is designed for plug-and-play operation with QSFP28 ports and prioritizes energy efficiency and stable performance for high-throughput environments.

Advantages

This 1m passive copper DAC provides reliable 100G transmission with minimal latency and reduced power consumption compared with active or optical alternatives. Its compact, single-cable form factor simplifies rack cabling and reduces space usage while delivering consistent signal integrity over short distances. The product is compatible with standard QSFP28 interfaces, ensuring straightforward installation and interoperability in many common data center setups.

Suitable for

• Short-reach server-to-switch and switch-to-switch connections in data centers
• High-density rack deployments and top-of-rack switching
• Low-latency environments such as high-performance computing clusters
• Cost- and power-sensitive network infrastructure where optical transceivers are unnecessary

Key specifications

• Interface: QSFP28 to QSFP28
• Length: 1 meter
• Transmission: Passive copper
• Data rate: 100 Gigabit Ethernet
• Latency: low, suitable for short-reach applications
• Form factor: twinaxial cable with QSFP28 connectors

How to use

Connect each QSFP28 connector to the corresponding QSFP28 port on your network devices, ensuring the latch engages and the plug is seated securely. The cable is intended for short-reach connections within racks or between adjacent racks; avoid tight bends and excessive cable strain to maintain signal integrity. No additional configuration is typically required — the link should negotiate automatically at 100G if both endpoints support the standard.

Recommendations

Install the cable in clean equipment bays and route it to prevent sharp bends; maintain recommended bend radius for twinax cables. Verify QSFP28 port compatibility and firmware support on connected devices if you encounter link issues. For runs longer than 1 meter or for environments requiring optical isolation, consider appropriate optical transceivers or active DAC alternatives.