Cable DAC CBO QSFP28 SC282801L3M26 3 m — Cable de cobre Direct Attach QSFP28, 3 metros

The CBO DAC cable QSFP28 SC282801L3M26 3 m is a QSFP28 direct-attach copper (DAC) cable designed for 100GbE short-reach links in data center environments. This fixed copper connection provides a low-latency, power-efficient alternative to optical transceivers for connections between compatible switches, routers and network adapters. At 3 metres length it is intended for rack-to-rack or within-rack interconnects where a reliable, maintenance-free physical link is required without the complexity of separate transceivers and fiber patching.

Advantages

This QSFP28 DAC cable offers deterministic latency and reduced power consumption compared with optical modules, since no transceiver or optical power budget is required. The integrated connector assemblies simplify installation and reduce component count, lowering potential points of failure. Its passive copper construction enables plug-and-play deployment in compatible 100GbE ports and eliminates the need for optical cleaning or fiber management in short-distance topologies.

Suitable for

• Short-reach 100GbE links within server racks or between adjacent racks
• High-performance switch-to-switch or adapter-to-switch connections
• Data center aggregation and spine-leaf topologies requiring consistent low latency
• Environments prioritizing lower power consumption and simplified cabling

Key specifications

• Interface type: QSFP28 to QSFP28 direct-attach copper
• Nominal data rate: 100 Gigabit Ethernet
• Cable length: 3.0 metres
• Cable type: Copper twinax, fixed assembly
• Typical reach: short-reach (within or between racks)
• Latency: low, deterministic electrical connection
• Compatibility: intended for devices with QSFP28 ports supporting DAC interconnects

How to use

Power off or follow hot-plug guidance of your equipment as recommended by the switch or adapter manufacturer, then insert each QSFP28 plug into the corresponding port until the connector latches. Ensure the port configuration on both ends is set for a copper DAC link if device firmware requires selection. After connection, verify link status via the device management interface and check for correct speed and lane mapping. For removal, depress the latch and gently withdraw the connector to avoid mechanical stress on the port.

Recommendations

Use the cable for short, high-speed interconnects inside racks or between adjacent racks where 3 metres provides sufficient reach. Avoid routing through tight bends or subjecting the cable to sustained mechanical strain; maintain bend radii recommended by equipment vendors. Confirm port compatibility and firmware support for DAC assemblies before deployment, and keep the connectors free of contaminants—although direct-attach copper eliminates optical cleaning requirements, good handling practices help maintain reliable electrical contact.