Cable InfiniBand CBO MFA2P10-A001-BO 1 m SFP28 aqua

CBO InfiniBand Cable MFA2P10-A001-BO 1 m SFP28 aqua is a 1‑metre direct‑attach link cable compatible with SFP28 ports. It is intended for short‑reach, high‑speed connections within racks and between nearby network devices. The aqua jacket identifies the cable for InfiniBand or high‑speed fabric deployments and the compact SFP28 form factor supports dense port layouts commonly used in switches, servers and storage arrays.

Advantages

The cable offers a compact, low‑latency connection without the need for transceivers, reducing power and space requirements. Its 1 m length is suitable for rack‑level interconnects and reduces cable clutter while maintaining signal integrity for short links. The SFP28 interface supports 25 Gbps class links and is compatible with equipment that accepts SFP28 direct‑attach copper or passive/active cable assemblies. The colored jacket improves physical identification in dense cabling environments.

Suitable for

Key specifications

How to use

Insert each SFP28 end of the cable into the corresponding SFP28 port on the network devices until the connector latches engage. Ensure devices are powered down or follow hot‑swap procedures recommended by the equipment manufacturer if inserting while powered. Route the cable to avoid sharp bends and maintain the minimum bend radius specified by the equipment vendor. Verify link status on both devices to confirm a successful connection.

Recommendations

Use this 1 m SFP28 cable for short, high‑speed links within racks and between adjacent units. Avoid excessive bending or tension on the cable, and label each end as needed for easy identification during maintenance. Confirm compatibility with the specific switch, server or storage hardware and its supported SFP28 cable types before deployment.