Cable Network TAP CBO TAPCABLE-2M-BL — 2 m SFP+ 10 Gbit/s cable de monitorización pasivo

CBO TAP Cable TAPCABLE-2M-BL is a 2 m SFP+ passive TAP cable designed for 10 Gbit/s network monitoring and packet capture. The cable connects two SFP+ ports directly to mirror traffic for analysis, intrusion detection, or troubleshooting without interrupting live links. Its compact form factor and low latency make it suitable for lab setups, monitoring appliances and inline security tools where accurate traffic replication and minimal signal distortion are required.

Advantages

The passive SFP+ design requires no external power or configuration and preserves native link behaviour while providing a mirrored feed for monitoring devices. At 2 meters length the cable offers a balance between reach and compact cable management in racks and test benches. Its 10 Gbit/s capability supports full-rate packet capture for high-speed networks and reduces the need for additional media converters or optical transceivers when used with compatible SFP+ monitoring ports.

Suitable for

• Packet capture and analysis in lab and production environments
• Intrusion detection and inline security appliances
• Non-intrusive troubleshooting and link verification
• Connecting SFP+ monitoring ports in racks and test benches

Key specifications

• Connector type: SFP+ direct attach cable (fixed SFP+ ends)
• Maximum data rate: 10 Gbit/s
• Length: 2 metres
• Operation: Passive TAP (no external power)
• Latency: low propagation delay suitable for monitoring
• Use case: designed for monitoring, packet capture and inline appliances

How to use

Insert each SFP+ end into the corresponding SFP+ ports on the live link and the monitoring device according to port labelling. Ensure both ends are seated firmly and that connected devices support passive SFP+ DAC connections. The cable will present a mirrored feed to the monitoring appliance without requiring configuration changes to the live network devices; verify link status and start packet capture or monitoring software on the appliance. For inline security use, follow vendor guidance for placing the monitoring device between the two active ports.

Recommendations

Use the cable within standard equipment bays and avoid tight bends near the connectors; confirm device compatibility with SFP+ passive DACs and 10 Gbit/s operation before deployment. For best monitoring results, place the monitoring appliance on a secure, stable rack shelf and verify that traffic capture software is configured to handle full line rate.