Cable óptico activo AOC CBO Marconi SFP-AOC-10G-15M 10Gb/s, 15 m

The AOC CBO Marconi SFP-AOC-10G-15M Active Optical Cable provides a direct 10 Gb/s SFP+ connection over a 15-metre optical link. Designed for high-density server, switch and storage interconnects, this BlueOptics active optical cable integrates the optical transceiver and fiber in a single assembly to simplify installation and reduce component count. The cable supports 10 Gigabit Ethernet links with low latency, reduced weight compared with copper cabling, and immunity to electromagnetic interference, making it suitable for modern data center and enterprise networking environments.

Advantages

The integrated design removes the need for separate SFP+ transceivers and copper patch cables, lowering power consumption and simplifying spare-parts management. At 15 metres length the cable enables flexible rack-to-rack and aisle connections while maintaining signal integrity at 10 Gb/s. Its optical construction reduces susceptibility to EMI and provides lighter cabling that eases airflow and rack organization. The product is factory-terminated and tested for reliable link performance without field termination.

Suitable for

• 10 Gb/s server-to-switch connections in data centers
• Top-of-rack and end-of-row interconnects
• Storage area network links requiring low latency
• Environments where EMI immunity and reduced cable weight are needed

Key specifications

• Interface: SFP+ compatible plug-and-play optical cable
• Data rate: 10 Gbit/s full duplex
• Length: 15 metres
• Medium: active multimode optical assembly with integrated transceivers
• Latency: low propagation delay suitable for server and storage networks
• EMI: immune to electromagnetic interference due to optical transmission
• Weight: lighter than equivalent copper assemblies for improved cable management

How to use

Install the AOC by inserting each SFP+ connector into the SFP+ port of the devices to be connected until the latch engages. Ensure both endpoints support SFP+ AOC modules and are powered off or support hot-plug insertion per the equipment manufacturer’s guidance. After seating both ends, verify link status and configure link speed and duplex in the host devices if required. Avoid tight bends and protect the cable from sharp edges; follow rack-routing practices to prevent stress on the connectors.

Recommendations

Store and route the cable according to standard fiber handling practices: maintain a minimum bend radius, avoid kinks, and keep connectors clean. Use AOC assemblies for short-to-medium length inter-rack links where reduced weight, EMI immunity, and integrated transceiver convenience are priorities. Confirm compatibility with switch and server vendor compatibility lists when deploying in managed environments.