Cable óptico activo AOC CBO Meraki QSFP-100G-AOC-5M 100G, QSFP a QSFP, 5 m

The AOC CBO Meraki QSFP-100G-AOC-5M is a 100 Gbps active optical cable with QSFP-to-QSFP connectivity over a 5 meter distance. It integrates optical transceivers and a multimode fiber assembly into a single, factory-terminated cable, providing a compact, power-efficient alternative to separate pluggable modules and external fiber. This cable is intended for short-reach, high-bandwidth links in data centers and network fabrics where reliable 100G connections between switches, routers or servers are required.

Advantages

This active optical cable delivers 100 Gbps throughput with low latency and reduced power consumption compared with discrete transceiver plus patch-cord solutions. Its QSFP-to-QSFP form factor simplifies installation and reduces the number of field-terminated connectors. Factory-terminated optical terminations improve signal integrity and lower the risk of connector-related errors. The integrated design reduces cabling complexity in dense racks and helps maintain consistent optical performance across a 5 m link.

Suitable for

• Short-reach 100G interconnects within data center rows and racks
• Spine-leaf network topologies requiring 100G uplinks
• Server-to-switch and switch-to-switch aggregation links
• High-density switch deployments where space and power efficiency matter

Key specifications

• Interface: QSFP to QSFP
• Data rate: 100 Gbps aggregate
• Cable type: Active optical cable (integrated transceivers and fiber)
• Reach: 5 meters
• Application: Short-reach data center interconnects, switch and server links
• Latency: Low, suitable for high-throughput switching environments
• Power: Lower system power than separate transceiver plus copper/fiber patching

How to use

Insert each QSFP connector into corresponding QSFP ports on networking equipment that supports 100G QSFP links. Ensure ports are powered down or in a safe state if required by your equipment vendor before insertion or removal. Confirm link status and speed through the switch or server management interface, and verify lane alignment and firmware compatibility if the host requires vendor settings. Route the 5 m cable to avoid tight bends and mechanical stress; secure the cable within the rack to prevent accidental disconnection.

Recommendations

Use this AOC for short-hop 100G links where optical isolation and lower power are preferred. Keep bend radius within manufacturer guidelines, avoid exposure to excessive heat or liquids, and check host switch compatibility lists if hardware-level interoperability is a concern.